#
# U-Boot bootscript for EMMC/SD images created by Yocto.
#

#
# Set device tree filename depending on the board ID (if defined)
#
if test -n "${board_id}"; then
	setenv fdt_file uImage-${soc_family}-ccimx6sbc-id${board_id}.dtb
else
	#
	# Set device tree filename depending on the hardware variant
	#
	if test "${module_variant}" = "0x02"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x03"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x04"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x05"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-w.dtb
	elif test "${module_variant}" = "0x06"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x08"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc.dtb
	elif test "${module_variant}" = "0x0a"; then
		setenv fdt_file uImage-imx6dl-ccimx6sbc-w.dtb
	elif test "${module_variant}" = "0x0b"; then
		setenv fdt_file uImage-imx6dl-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x0c"; then
		setenv fdt_file uImage-imx6dl-ccimx6sbc.dtb
	elif test "${module_variant}" = "0x0e"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc.dtb
	elif test "${module_variant}" = "0x0f"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc.dtb
	elif test "${module_variant}" = "0x11"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x12"; then
		setenv fdt_file uImage-imx6q-ccimx6sbc-wb.dtb
	elif test "${module_variant}" = "0x13"; then
		setenv fdt_file uImage-imx6dl-ccimx6sbc-wb.dtb
	else
		echo "------ Using default fdt_file"
	fi
fi

# To detect if we are booting from SD card we get the UUID of the
# boot partition and compare with the default one for the EMMC
part uuid mmc ${mmcbootdev}:${mmcpart} bootpart
if test "${bootpart}" != "${part1_uuid}"; then
	setenv mmcroot /dev/mmcblk${mmcbootdev}p2
fi
dboot linux mmc ${mmcbootdev}:${mmcpart}
