From 6be939c535b605479a4fef705767e0e68e34c2b8 Mon Sep 17 00:00:00 2001 From: Alex Gonzalez Date: Fri, 16 Dec 2016 17:30:36 +0100 Subject: [PATCH] meta-digi-arm: firmware-qualcomm: qcom_cfg.ini: Remove unused entries. The following document, JQCA61x4, QCA65x4, and QCA937x Configuration Parameters Specification 80-Y7674-11 Rev. J September 30, 2016 Contains a list of unused configuration arguments in page 29. This commit removes those listed arguments that appeared on the default configuration file to avoid confusion. Signed-off-by: Alex Gonzalez --- .../firmware-qualcomm/wlan/qcom_cfg.ini | 15 --------------- 1 file changed, 15 deletions(-) diff --git a/meta-digi-arm/recipes-bsp/firmware-qualcomm/firmware-qualcomm/wlan/qcom_cfg.ini b/meta-digi-arm/recipes-bsp/firmware-qualcomm/firmware-qualcomm/wlan/qcom_cfg.ini index fff4052f0..4900c1c45 100644 --- a/meta-digi-arm/recipes-bsp/firmware-qualcomm/firmware-qualcomm/wlan/qcom_cfg.ini +++ b/meta-digi-arm/recipes-bsp/firmware-qualcomm/firmware-qualcomm/wlan/qcom_cfg.ini @@ -7,8 +7,6 @@ gEnableRxThread=1 -gEnableIdleScan=0 - # Increase sleep duration (seconds) during IMPS # 0 implies no periodic wake up from IMPS. Periodic wakeup is @@ -29,12 +27,6 @@ gEnableSuspend=3 # 7 = 11b only 8 = 11ac only. gDot11Mode=0 - -# CSR Roaming Enable(1) Disable(0) - -gRoamingTime=0 - - # Assigned MAC Addresses - This will be used until NV items are in place # Each byte of MAC address is represented in Hex format as XX @@ -103,19 +95,12 @@ gEnableDFSMasterCap=1 ImplicitQosIsEnabled=0 gNeighborLookupThreshold=76 -gNeighborReassocThreshold=81 #Check if the AP to which we are roaming is better than current AP in terms of RSSI. #Checking is disabled if set to Zero.Otherwise it will use this value as to how better #the RSSI of the new/roamable AP should be for roaming RoamRssiDiff=3 -# If the RSSI of any available candidate is better than currently associated -# AP by at least gImmediateRoamRssiDiff, then being to roam immediately (without -# registering for reassoc threshold). -# NOTE: Value of 0 means that we would register for reassoc threshold. -gImmediateRoamRssiDiff=10 - # SAP auto channel selection configuration # 0 = disable auto channel selection