Each platform now has only one base device tree, meant for the i.MX8DX variants
of the ccimx8x boards. Apply the QXP overlay in the bootscript if the SOC is
identified as an i.MX8QXP.
Since we want to give this overlay a higher priority than the SOM overlays
(wifi and bluetooth), prepend it to the overlay list after appending the SOM
overlays.
https://jira.digi.com/browse/DEL-7100
Signed-off-by: Gabriel Valcazar <gabriel.valcazar@digi.com>
These overlays aren't handled in our bootscript, but we make them available for
users in case they wish to use alternative interface configurations.
https://jira.digi.com/browse/DEL-7100
Signed-off-by: Gabriel Valcazar <gabriel.valcazar@digi.com>
Remove the old wb device trees from the ccimx8x-sbc-express and ccimx8x-sbc-pro
configuration files and add the ccimx8x wifi and bt overlays. Modify both
platforms' bootscripts to apply the overlays depending on board_id, hardware
capabilities or module variants.
https://jira.digi.com/browse/DEL-7100
Signed-off-by: Gabriel Valcazar <gabriel.valcazar@digi.com>
This commit adds a installation script that uses fastboot support to
update the target firmware.
Signed-off-by: Mike Engel <Mike.Engel@digi.com>
https://jira.digi.com/browse/DEL-6845
Additionally:
- The handling of gpios has been swapped so 'Set low XBEE_SLEEP_RQ' is done
before 'Power cycle XBEE_RESET_N' to assure the device doesn't enter sleep mode.
- Removed ExecStop entry from systemd service since it's doing nothing.
https://jira.digi.com/browse/DEL-6424https://jira.digi.com/browse/DEL-6423
Signed-off-by: Hector Bujanda <hector.bujanda@digi.com>
WPA and P2P configuration files are basically the same between all
platforms, so we remove all duplicated files to use a common file
and modify it in the recipe logic.
Signed-off-by: Arturo Buzarra <arturo.buzarra@digi.com>
With the arrival of DualX variants, the devicetree files have changed
their names to include the soc type (qxp, dx).
Signed-off-by: Hector Palacios <hector.palacios@digi.com>
https://jira.digi.com/browse/DEL-6641
This recipe adds a script and a related systemd service that
configures two GPIOs (user defined, or else platform-defaults) as
output and sets them to the appropriate value for initializing the
XBee socket:
- XBEE_SLEEP_RQ: is set low, for running the XBee
- XBEE_RESET_N: is set low and then high, to reset the XBee
The service triggers on the condition that the UART TTY device node
pointed to by variable XBEE_UART exists.
Signed-off-by: Hector Palacios <hector.palacios@digi.com>
https://jira.digi.com/browse/DEL-6366
Hector Palacios
Gabriel Valcazar
Mike Engel
Hector Bujanda
Javier Viguera
Arturo Buzarra