This is a Consumer dual-core 1GHz, 4GB eMMC, 1GB DDR3, 0/+70C variant
without bluetooth, no wireless, no kinetis.
https://jira.digi.com/browse/DEL-4280
Signed-off-by: Arturo Buzarra <arturo.buzarra@digi.com>
On a CC6, the 'env default -a' command deletes the 'soc_family' variable
that is used on the U-Boot boot scripts to configure the name of the
device tree file to load.
Then if we try to boot into recovery directly (without a reset) because
the variable is not available, it fails to compose the correct name for
the fdt, and gives the error:
reading uImage--ccimx6sbc-id129.dtb
** Unable to read file uImage--ccimx6sbc-id129.dtb **
Force a reset, so the 'soc_family' variable is available again and the
correct fdt_file is loaded.
While on it, add some blank lines to the 'recovery reboot' message, so
it's easier to read.
Signed-off-by: Javier Viguera <javier.viguera@digi.com>
The setting of 'bootcmd' in the script was done using single quotes, which
doesn't expand variables. As a consequence the following variables must
be defined again (during the execution of the second part of the script):
- mmcdev
- INSTALL_LINUX_FILENAME
- INSTALL_ROOTFS_FILENAME
This patch changes the single quotes with double quotes, so that these
variables are expanded during the setting of 'bootcmd' with the values
assigned at the begining of the installation script (notice these are
not dynamically generated so there is no risk to expand them).
At the same time we need to escape with a backslash:
- double quotes containing strings
- variables that we don't want to expand (like the return value $?)
Signed-off-by: Hector Palacios <hector.palacios@digi.com>
- Add semi-colons to instructions inside 'setenv' commands
- Remove semi-colons in instructions where they are not needed (for
consistency with the rest of instructions)
Signed-off-by: Hector Palacios <hector.palacios@digi.com>
Old versions of u-boot 'v2013.0x' have a bug in the shell's test command
that makes structures like:
if test "${not-existing}" = "0x01"; then ...
if test -z "${not-existing}"; then ...
to fail when the checked variable does not exist.
So implement workarounds in the updater script to overcome this problem.
This is needed because the script may be used in modules with an old
pre-installed u-boot.
https://jira.digi.com/browse/DEL-2231
Signed-off-by: Javier Viguera <javier.viguera@digi.com>
The install script allows for an easy deployment of the DEY firmware
artifacts into the eMMC of the ConnectCore 6 by using a micro SD card.
The install script:
- updates U-Boot
- resets the U-Boot environmnet to default values
- formats the User Data partition of the eMMC
- installs the firmware images (linux and rootfs partitions)
- resets/starts the system
Signed-off-by: Hector Palacios <hector.palacios@digi.com>
https://jira.digi.com/browse/DEL-2192
Arturo Buzarra
Javier Viguera
Hector Palacios
David Escalona